PVA 500g Water Soluble Filament


PVA 500g Water Soluble Filament

  • Supporting filament
  • Water soluble
  • Easy to print

39,00 32,00 (+DDV)

  • Description
  • Additional information


PVA filament with a net weight of 0,5 kg (1.10 lbs), winded on the reel of an outer diameter of 210 mm, with an inside opening of 60 mm and a width of 62 mm. The filament is vacuum-sealed and contains a bag that absorbs moisture and allows the filament to remain fresh. The thickness of the PVA filament is 1.75 mm and it is produced in a natural shade.

PVA filament is a water-soluble support filament. It is very popular because it is printed at similar temperatures as PLA filament, and they make a good match.
A print with PVA filament looks transparent and slightly yellow. It is most commonly used in 3D printers with a double printhead, one head prints basic material (e.g. PLA, PETG or ABS), while the other is printing supportive PVA material to provide support at all major angles where otherwise basic material would be run. After printing, insert the product into lukewarm water and within 12-24 hours, the PVA material will dissolve, leaving your base material and a wonderful product.
For good results, you must print at a temperature of 190-210 ° C and the printing table should be heated to 50-60 ° C. Please note that the range in the print temperature may slightly differ depending on the use of other printers.

Additional information

Weight 0.6 kg
Dimensions 230 × 230 × 65 mm
Filament Diameter